Material Managing Energy UNIT one
This electrical power unit is made for the fork lift marketplace, consisting of really efficient gear pump, DC motor, guide raise and reduced valve, tank, ect. The up and down motion are managed by the lever from the guide release valve, which can be equipped with an electric switch to activate the motor. The lowing velocity is managed by the stress compensated flow management valve.
one. The duty of this electrical power unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean every one of the hydraulic parts concerned before set up of the energy unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst, which really should also be clean and cost-free of impurities, N46 hydraulic oil is recommended .
four. Oil altering is required just after the first 100 operation hrs, afterwards after just about every 3000 hours.
five. The electrical power unit proven is created to be mounted horizontally.
Material Managing Power UNIT two
This power unit attributes electrical power up gravity down circuit. Activate the begin solenoid to start the motor to lift the machine. The lowing motion is activated through the solenoid valve with the reducing speed managed from the strain compensated movement manage valve. Products of this series could be widely used in the marketplace of logistic devices including fork lift, mini lift table, etc.
one. The duty of this power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean every one of the hydraulic elements concerned in advance of mounting the power unit.
three. Viscosity of your hydraulic oil shoud be 15~46 cst,which really should also be clean and no cost of impurities, N46 hydraulic oil is suggested .
4. Oil shifting is needed right after the original a hundred operation hours,afterwards the moment each and every 3000 hrs.
five. The energy unit really should be mounted horizontally.