Power UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE one
Standard Description
This power unit is made exclusively for the smaller lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit has been widely applied during the market of logistic gadgets which include minifork lift, scissors lift and ariel working platforms. The lower-ing movement is managed by the solenoid valve together with the pace managed by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Standard Description
This power unit is intended exclusively for that medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve plus the speed controlled by the adjustable needle valve. When the lift rises to a substantial positoin, however the power supply is minimize, the lowering movement is managed from the manual override perform.
Electrical power UNITS FOR LIFT TABLE three
General Description
This electrical power unit is built solely for your substantial lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve plus the speed managed by a stress compensated flow control valve.
Electrical power UNITS FOR LIFT TABLE 4
General Description
This electrical power unit is designed exclusively for the large lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve plus the speed managed by the adjustable needle valve. Once the lift rises to a high positoin, but the power supply is minimize, the decreasing movement is controlled from the manual override function.
Specific Notes
one. This electrical power unit is of S3 duty cycle, which can only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean every one of the hydraulic components concerned ahead of installation of the electrical power unit.
3. Viscosity in the oil shoud be 15~46 cst,which really should also be clean and no cost of impurities.N46 hydraulic oil is encouraged.
4. Oil altering is required following the preliminary 100 operation hrs,afterwards once every single 3000 hours.
five. The power unit shown is made to be mounted vertically.