Shaanxi zlz connecting intermediate shaft elastic pin gear coupling

The zlz elastic pin gear coupling with the intermediate shaft is suitable for the transmission shaft system of the coaxial line. The longitudinal section shear strength of the nylon rod can be used to transmit a large torque. The working temperature is -20-70 degrees, which can be partially Instead of gear couplings, it has the ability to compensate for axial deviation and general shock absorption performance.

zlz connect to the intermediate shaftElastic pin gear couplingIt uses several pins made of non-metallic materials and is placed in the mating hole between the two halves of the coupling and the inner surface of the outer ring, and the two halves of the coupling are connected through the pin to transmit torque.

The five assembly steps of the zlz elastic pin gear coupling with the intermediate shaft are analyzed as follows: After the individual parts of the coupling are processed, we are about to assemble it.The main components are the processed two-half coupling and outer ring, several nylon rods, two baffle plates, and several screws.

1. Put the outer ring on the half-coupling and install a suitable baffle on the flange of the half-coupling, and fix the outer ring and the half-coupling with screws.

2. Fill the nylon rod into the hole between the outer ring and the half coupling.

3. Install the other half coupling in the outer ring.

4. Put another nylon rod into the hole of the outer ring and half coupling.

5. Then fix the other baffle with the outer ring of the coupling with screws.

The assembly of the zlz elastic pin gear coupling with the intermediate shaft takes three steps: the detailed method of assembling and assembling the elastic pin gear coupling is extremely important. If the method is missed, it may cause loss to our operation. .When assembling, adjust the axial, radial and angular deviation of the coupling first, and confirm the deviation category according to the shaft diameter.

Assembly method:

1. Put the outer ring on the half coupling, install the partition, install the half coupling on a shaft, and install the pin.

2. Install the other half of the coupling in the outer ring and install the pin.

3. Install the partition, flow with screws, and install another shaft.

Assembly method:

1. Loosen the screws on the partition, remove the partition and store it in the pin.

2. Loosen the screws on the base of the drive end and remove the drive.

3. Loosen the top wire on the coupling and lose it, and pull out the coupling with a triangle puller.

technical parameter: